Spherical wind turbine for flat dwellers wins 2018 James Dyson Award | Small Electrical Transformer

[F24F] AIR-CONDITIONING; AIR-HUMIDIFICATION; VENTILATION; USE OF AIR CURRENTS FOR SCREENING (removing dirt or fumes from areas where they are produced B08B 15/00; vertical ducts for carrying away waste gases from buildings E04F 17/02; tops for chimneys or ventilating shafts, terminals for flues F23L 17/02)

Inventor(s): Andrew Marshall (Dallas, TX), Nishtha Sharma (Richardson, TX) Assignee(s): Board of Regents, The University of Texas System (Austin, TX) Law Firm: Schott, P.C. (1 non-local offices) Application No., Date, Speed: 15877806 on 01/23/2018 (350 days app to issue)

Steve Ward, an Austin, Texas-based electrical engineer who specializes in embedded power electronics, and is well-known to the Tesla coil community for his solid-state design contributions, provided additional information on the performance of Wingate’s new coil.

Ironically, things started working when I used parts taken off scrap boards. I knew more by then, so I had a certainty about some things.

BURNDY®, a leading manufacturer and provider of wire management solutions to the Solar PV industry, announces the addition of the new ACC-FPV90 wire management clip to the WILEY line. The ACC-FPV90 wire management clip is made of corrosion resistant 304 stainless steel, which makes it a durable, long lasting and reliable solution for all environments. The ACC-FPV90 is easy to install and slides 90 degrees on to module frames of various thicknesses. The ACC-FPV90 accommodates 1 to 2 PV cables up to 8.0 mm in diameter.

They are normally placed in the near vicinity or neighborhood and connect ten or fewer consumers. The consideration of lowest total owning cost (TOC) is a key factor influencing the purchasing decisions of distribution transformers by electric utilities.

Prolly worth mentioning Page 89:http://snebulos.mit.edu/projects/reference/MIL-STD/MIL-HDBK-217F-Notice2.pdf

The amount of power that can be transferred from the inductor (the charging pad) to the receiver (the mobile device) is dependent on many things, including the number of wire coils in both devices, the strength of the magnet in the inductor, and the distance between the inductor and the receiver. The latter explains the design of most wireless chargers today: smartphones need to sit very close to (i.e., directly on top of) the wireless charger to receive the most amount of energy possible.

Before writing “with bonus points for PWM ability at a frequency above human hearing. I”” –as that has nothing to do with the MOSFET, but rather with the MOSFET driver.

Fuel data collection unit with temperature compensation and over-fill prevention Patent No. 10173884 

Inventor(s): Sangseok Park (Flower Mound, TX) Assignee(s): DIALOG CORPORATION (Montreal, Quebec, CA) Law Firm: BainwoodHuang (Local + 4395 other metros) Application No., Date, Speed: 15401243 on 01/09/2017 (729 days app to issue)

Vbat -> G-VCC -> MOSFET gates (G- for gates) Vbat -> L-VCC -> motors, WiFi, spinney flashy thing (L-oad) Vbat -> 3VCC -> unregulated or 3v3 regulated rail